Cloud9 Hair Straightener Repair by Trevor Briscombe

Cloud 9 Normal Width Irons

The normal irons are about 1" wide.

There are three versions of the normal width irons and they all look the same:

They are all fitted with either 70ohm or 160ohm heaters. You cannot tell what heater resistance they use without taking the irons apart and checking!

The 1.0 and 1.1 models have a heater and thermal fuse wired in series on both sides. We sell a heater and thermal fuse combo suitable for these models:

The 1.2 model is the current model. Some of them have the heaters and thermal fuses in series like the 1.0 and 1.1 models (and therefore use the spare parts linked to above), however others have them separate, only have a thermal fuse on the switch side and only have one calibration variable resistor. If you have 1.2 model with a separate thermal fuse, then theses are the heater spare parts you need:

Photos

This is the correct way round for the hinge spring:

On the switch side there is a screw hidden underneath the lable (bottom arm on right in this photo):

Here is a C9 1.2 PCB that has a separate thermal fuse only on one side and a single calibration variable resistor:

 


The information provided on this website is intended for use by people competent at repairing electrical products. If you are not confident about carrying out a safe and reliable repair, please consider our repair service. To state the obvious... Irons repaired incorrectly can be very dangerous!


   

This page was last updated at 10:23pm on 15th February 2015

All content © Fogma Ltd 2013-2017. Website Terms & Conditions

We are an independent company and are not associated with Cloud9 whatsoever. More...