Cloud 9 Wide Plate Irons
There are three versions of the wide irons and they all look the same:
They are all fitted with either 70ohm or 160ohm heaters that are the same size as the ones used in the normal width irons. You cannot tell what heater resistance they use without taking the irons apart and checking!
The 1.0 and 1.1 models have a heater and thermal fuse wired in series on both sides. We sell a heater and thermistor combo suitable for these models:
The 1.2 model is the current model. Some of them have the heaters and thermal fuses in series like the 1.0 and 1.1 models (and therefore use the spare parts linked to above), however others have them separate and only have a thermal fuse on the switch side. If you have 1.2 model with a separate thermal fuse, then theses are the heater spare parts you need:
Although these look similar to the GHD SS wide plate models, the plastic plate mounting parts are not compatible with the GHD equivalent.
The information provided on this website is intended for use by people competent at repairing electrical products. If you are not confident about carrying out a safe and reliable repair, please consider our repair service. To state the obvious... Irons repaired incorrectly can be very dangerous!
This page was last updated at 11:07pm on 17th January 2015
All content © Fogma Ltd 2013-2019. Website Terms & Conditions
We are an independent company and are not associated with Cloud9 whatsoever. More...